To the knowledge base

Integrating FRITZ!Repeater into the Mesh via Wi-Fi

Integrate your FRITZ!Repeater into the Mesh of your FRITZ!Box via Wi-Fi to increase the Wi-Fi range of your home network easily and efficiently. As a Mesh Repeater, the FRITZ!Repeater then automatically adopts all of the settings from the FRITZ!Box (Mesh Master), such as Wi-Fi access information and guest access. In the Mesh, your wireless devices automatically connect to the wireless access point with the best Wi-Fi reception.

Changes in the Mesh can then be easily made in the Mesh Master. The Mesh Master automatically transmits the new settings to all of the Mesh Repeaters. If you still want to access the user interface of the Mesh Repeater, use the password from the Mesh Masters to log into the Mesh Repeater.

As soon as the FRITZ!Repeater is integrated into the Mesh, it is marked with the Mesh symbol in the user interface of the Mesh Master:

Connection scenario for wireless bridge mode

Requirements / Restrictions

  • FRITZ!OS 7 or later is installed on the FRITZ!Repeater.

    Important:You can find instructions on setting up older FRITZ!Repeater models that do not support Mesh at en.avm.de/service under "FRITZ!WLAN > More models > [FRITZ!Repeater model] > Knowledge Base" if you search for "connect repeater".

Note:All instructions on configuration and settings given in this guide refer to the latest FRITZ!OS for the FRITZ!Box.

1 Loading the FRITZ!Repeater's factory settings

To perform the following steps, the FRITZ!Repeater must be set to factory settings:

2 Adding a FRITZ!Repeater to the Mesh by button

You must push a button to add the device to the Mesh. It does not matter whether you push the button on the Mesh Master or the Mesh Repeater first. We recommend the following order:

  1. For setup, position the FRITZ!Repeater near the Mesh Master.
  2. Wait about 1 minute until the Connect LED on the FRITZ!Repeater flashes more slowly or the Power and WLAN LEDs on the FRITZ!Repeater remain lit.
  3. Briefly push the Connect or WPS button on the FRITZ!Repeater (for about 1 second) and release it again. When you release the button, the Connect LED starts to flash quickly or the WLAN LED starts to flash.
  4. Within 2 minutes: Push and hold down the WLAN WPS button on the Mesh Master for about 6 seconds until its WLAN LED flashes.
  5. The FRITZ!Repeater is fully integrated into the Mesh about 5 seconds after the LED for connection quality glows green or one or more signal strength LEDs on the new FRITZ!Repeater remain lit.

3 Finding the ideal location for the FRITZ!Repeater

To extend the range as much as possible, the FRITZ!Repeater requires a fast and stable Wi-Fi connection to the FRITZ!Box:

  1. Position the FRITZ!Repeater so that, depending on the model, at least three of its five signal strength LEDs light up or the LED for connection quality glows green and not orange. You can find tips on positioning it in the guide Finding the ideal location for the Mesh Repeater.