Baza wiedzy
AVM Content
- FRITZ!Box 7590
- FRITZ!Box 7583
- FRITZ!Box 7560
- FRITZ!Box 7530
- FRITZ!Box 7490
- FRITZ!Box 7272
- FRITZ!Box 6890 LTE
- FRITZ!Box 6850 LTE
- FRITZ!Box 6840 LTE
- FRITZ!Box 6820 LTE
- FRITZ!Box 6660 Cable
- FRITZ!Box 6591 Cable
- FRITZ!Box 6490 Cable
- FRITZ!Box 5491
- FRITZ!Box 5490
- FRITZ!Box 4040
Forgot password for the user interface of FRITZ!Repeater
You can protect the user interface of your FRITZ!Repeater against unauthorized access with a password. If you did not assign a password, after setting it up you must use the password and, if applicable, the username of the FRITZ!Box to log in. If you forgot the password, reset the password or load the factory settings. Then you can log in again and set a new password.
1 Using the FRITZ!Box password
If you did not assign a password for the repeater's user interface, you must use the password and, if applicable, the username of the FRITZ!Box to log in. In this case, use the FRITZ!Box password to log in.
2 Loading the factory settings
If you are not offered the option of sending a push service mail or you did not receive the email, you cannot open the user interface again until you load the factory settings:
- Plug the FRITZ!Repeater in.
- Wait about 1 minute until the FRITZ!Repeater starts and the Power and WLAN LEDs remain lit or the LEDs of the signal strength indicator flash.
- Push and hold down the WPS button down for about 15 seconds until all of the LEDs flash at the same time.
Fig.: Loading the FRITZ!Repeater's factory settings
- The Power and WLAN LEDs remains lit as soon as the factory settings have finished loading.