FRITZ!Box 7272 Serwis - Baza wiedzy

FRITZ!Box 7272 Serwis
Not your product?
This document is also available for the following products:

Loading the FRITZ!WLAN Repeater factory settings

When you load the factory settings, all of the individual settings you made in the FRITZ!WLAN Repeater are deleted. It makes sense to load the factory settings if you are going to use the FRITZ!WLAN Repeater at a different location or are planning to pass it on to another user, for example. In addition, this deletes incorrect settings that prevent the FRITZ!WLAN Repeater from functioning properly.

1 Loading the FRITZ!WLAN Repeater factory settings

Loading the FRITZ!WLAN Repeater factory settings with the "WPS" button

  1. Plug the repeater in.
  2. Wait until the "Power" LED remains lit.
  3. Push the "WPS" button and hold it down for about 15 seconds until all of the LEDs flash at the same time.

Loading the factory settings of the FRITZ!WLAN Repeater N/G

  1. Unplug the repeater.
  2. Plug it in again after 5 seconds.
    The "FRITZ" icon appears on the LED display after about 10 seconds:

    Fig.: "FRITZ" icon

  3. Tap the left touch point 2 or 3 times until the "load factory settings" icon appears:

    Fig.: "Load factory settings" icon

  4. Tap the middle of the LED display.
    The pulsating check mark ("confirm entry" icon) now appears on the LED display:

    Fig.: "Confirm entry" icon

  5. Tap the middle of the LED display again. This confirms that you would like to load the factory settings.

The repeater will now restart and load the factory settings. The process is completed when the "Power" and the "WLAN" LEDs both remain lit. The "Run WPS for the first time" icon appears on the display of the FRITZ!WLAN Repeater N/G.