FRITZ!Repeater 3000 Serwis - Baza wiedzy

FRITZ!Repeater 3000 Serwis
Not your product?
This document is also available for the following products:

FRITZ!Repeater cannot establish a wireless connection to FRITZ!Box

After you set up the FRITZ!Repeater, it cannot establish a wireless connection (WiFi) to FRITZ!Box. The "Connect" LED on the FRITZ!Repeater flashes quickly for a while and then flashes slowly again.

To resolve the problem, simply proceed as described below.

1 Enabling the 2.4 GHz frequency band

  1. Click "Wireless" ("WLAN") in the FRITZ!Box user interface.
  2. Click "Radio Network" in the "Wireless" ("WLAN") menu.
  3. Enable the 2.4-GHz frequency band. If only one frequency band is displayed, enable the Advanced View.
  4. Click "Apply" to save the settings.

2 Enabling the WPS function

  1. Click "Wireless" ("WLAN") in the FRITZ!Box user interface.
  2. Click "Security" in the "Wireless" ("WLAN") menu.
  3. Click on the "WPS Quick Connection" tab.
  4. Enable WPS.
  5. Select "Push-Button method (WPS-PBC, Push Button Configuration)" and click "Start WPS".

3 Briefly disabling the MAC address filter

If the MAC address filter is enabled in the FRITZ!Box, disable it for the duration of the setup procedure because otherwise the FRITZ!Repeater cannot to connect to the 5 GHz frequency band. The MAC address filter is not enabled in the factory settings:

  1. Click "Wireless" ("WLAN") in the FRITZ!Box user interface.
  2. Click "Security" or "Radio Network" in the "Wireless" ("WLAN") menu.
  3. Enable the option "Allow all new wireless devices". If the option is not displayed, enable the Advanced View.
  4. Click "Apply" to save the settings.

4 Disabling the keylock

  1. Click "System" in the FRITZ!Box user interface.
  2. Click "Buttons and LEDs" in the "System" menu.
  3. Click on the "Keylock" tab.
  4. Disable the "Buttons locked" checkbox.
  5. Click "Apply" to save the settings.