FRITZ!WLAN Repeater 310 Serwis - Baza wiedzy
Attempt to set up a wireless connection to a wireless router from another manufacturer fails
When you attempt to set up a wireless connection (WiFi) between the FRITZ!WLAN Repeater and a wireless router, the process cannot be completed successfully. After a connection attempt, the signal strength LEDs on the repeater flash continuously.
Important:If you are using a FRITZ!Box as the wireless router, follow the instructions in this guide.
Note:You can find information on the procedure for other wireless routers in the corresponding manual, or consult the manufacturer directly.
1 Briefly disabling the MAC address filter
Make sure that your wireless router allows you to register unknown wireless devices:
- Disable the wireless router's MAC address filter.
Note:You can re-enable the MAC address filter as soon as you have completed the configuration of the wireless connection between the FRITZ!WLAN Repeater and the wireless router.
2 Correcting the wireless router's wireless encryption method
In the factory settings, the FRITZ!WLAN Repeater supports the secure encryption methods WPA2 and WPA (Wi-Fi Protected Access) at the same time. Make sure that your wireless router is set for one of these encryption methods:
- Enable the encryption method WPA2 (CCMP) or WPA (TKIP) in the wireless router's settings.
3 Enabling the wireless router's WPS function
If you would like to use WPS to register the FRITZ!WLAN Repeater, you must enable the WPS function of your wireless router and use the correct WPS method.
- Enable the wireless router's WPS function and select "Push Button method" (WPS-PBC, Push Button Configuration) for the WPS method.
Now the wireless router is configured so that you can register the FRITZ!WLAN Repeater.